You're reading ...
.NEW Twinwoods & Bedford

Twinwoods & Bedford 06 Sawing the Table

The simulations in EEP and in TrainController showed us that this layout has interesting and varied traffic flow.

This gave us the confidence to now start sawing the wooden plates for the table. The challenge was to transfer the drawing from the PC to the boards to have the lines to saw along. We did this by placing strategic coordinates, read out from the Fusion360 drawing, on the boards. Two are needed for a straight line and at least three for a curve.

We used a bendable plastic strip to draw smooth curved lines on the board.

— 0 —

Advertisement

About RudyB

Hobbyist

Discussion

No comments yet.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

Archive of all posts

%d bloggers like this: